Mould Resin P + Hardener EPH 161-P, kit/ 1,17 kg

Description

Mould resin P

• Hard elastic, good edge strength
• Good grinding and polishing properties
• Thixotropic (non-drip)
• Manufactured in vacuum, so optimally free of air bubbles and homogeneous

This two-component epoxy resin is coloured black for Gelcoats (applied thickness 0.5–1 mm) in mould construction with high edge strength and good polishing properties. Mould resin P is processed and cured at room temperature in conjunction with epoxy resin laminates and laminating ceramics. In contrast to resin and metal systems, the surfaces are polishable.
The Gelcoat is hard-elastic, i.e. not brittle, and exhibits good edge strength.

Consumption: approx. 0.5–1 kg/m²

Processing:
EPH 161-P hardener:
90 minutes processing time for enhanced heat distortion properties, surfaces not resistant to styrene

Hardener EPH 161-P

Mixing ratio:
100 : 17 parts by weight of resin to hardener
Processing time: 90 minutes
Gelling time: approx. 4 hours
Curing time 24: hours at room temperature, followed by hot curing (together with the laminate) approx. 10 hours at 60 °C.

Max. heat distortion temperature after annealing (10 hours at 100 °C) approx. 130—140 °C (for short periods, permanent approx. 110 °C).

PoxySystems® is a registered trademark of R&G